Poser pro 2014 sr59/11/2023 ![]() However, when I was on the outer banks of NC, I got up one morning there, and noticed that it didn't come on, and did not come on for the entire trip back from the east coast to the west coast. ![]() But whenever I stopped for gas, and went to clean it, it wasn't dirty except for a couple of times. So at first, I just thought it was the sensor cover in front, getting messed up with bugs, etc. I drove across the country when I first got my truck, and about 45 minutes after I started the trip, the dang sensor light came on for the entire trip going from the west coast to the east coast! It would go off whenever I filled up with gas, only to come on again about 15 minutes or so after restarting my trip. Doing so, will then push the top of the sensor back, thus resulting in the sensor pointing ever so slightly upwards, thereby compensating for the lower position of the sensor in a TRD Pro grill. Regarding the washers, since you are trying to change the angle of the truck, putting the washers on each of the side bolts, is not what you want to do, but you want to put the washer on the TOP screw, between the grill and the sensor hole where the screw goes through. By that time, I had about 9000 miles on the truck, but the light went off around the mid-6000 mile range and has been working perfectly ever since. ![]() ![]() ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |